Lesson 1 of 19 · Module 1: System components and their representation

Introduction to control systems

Control System Engineering · EEE2510 · Sessions 1–2 · CO1

By the end of this lesson you can

  • Explain what a control system is and where it is used
  • Compare open-loop and closed-loop control
  • Classify control systems and describe the effects of feedback

Notes

A control system is an arrangement of components that makes a quantity follow a desired value: the speed of a motor, the voltage of a generator, the temperature of an oven or the angle of a robot joint.

Open-loop and closed-loop systems

Open loopClosed loop (feedback)
Uses the output?NoYes, the output is measured and compared with the reference
ExampleToaster with a timer, traffic lights on a fixed cycleRoom air conditioner, automatic voltage regulator
AccuracyDepends on calibrationHigh, corrects disturbances and parameter changes
StabilityNot a concernCan become unstable if badly designed
CostLowHigher (sensor and controller)

For a closed loop with forward path $G(s)$ and feedback $H(s)$, the closed-loop transfer function is

$$\frac{C(s)}{R(s)} = \frac{G(s)}{1 + G(s)H(s)}$$

Effects of feedback

  • Reduces the sensitivity of the output to changes in $G(s)$.
  • Reduces the effect of disturbances and noise inside the loop.
  • Changes the speed of response and the bandwidth.
  • Reduces the overall gain, and can cause instability.

Classification

Linear or nonlinear, time-invariant or time-varying, continuous or discrete (sampled-data), SISO or MIMO, and by application: regulators (hold a constant output) and servomechanisms (follow a changing reference).

Lecture

🎬
Lecture video
Coming soon. The recorded lecture for this lesson will appear here.

Exercises

  1. Name the reference input, controlled output, sensor and actuator in a home water-tank float valve.
    Show solution
    Reference: desired level (float arm setting). Output: water level. Sensor: the float. Actuator: the inlet valve moved by the float arm. It is a closed-loop system.
  2. $G(s) = 100$, $H = 0.1$. Find the closed-loop gain, and its change if $G$ drops by 10 %.
    Show solution
    $T = 100/(1 + 10) = 9.09$. With $G = 90$: $T = 90/10 = 9.0$, a change of about 1 %. Feedback reduced a 10 % change to 1 %.
  3. Why is a washing machine on a fixed programme an open-loop system?
    Show solution
    Each stage runs for a set time; the machine does not measure how clean the clothes are and adjust.