Lesson 19 of 19 · Module 4: State space analysis

Introduction to nonlinear systems

Control System Engineering · EEE2510 · Sessions 57–58 · CO6

By the end of this lesson you can

  • List common nonlinearities in control systems
  • Describe behaviours that only nonlinear systems show
  • Use the phase plane to visualise nonlinear motion

Notes

Real systems are only approximately linear. Superposition fails for nonlinear systems, so the methods of Modules 2 and 3 apply only near an operating point.

Common nonlinearities

NonlinearityWhere it appears
SaturationAmplifiers, valves at their limits, motor current limits
Dead zoneSmall inputs that produce no motion (static friction, motor start-up)
BacklashGear trains
Relay (on–off)Thermostats, bang-bang control
Coulomb frictionMechanical sliding contacts

Nonlinear behaviour

  • Several equilibrium points, each with its own stability.
  • Stability that depends on the size of the initial condition or input.
  • Limit cycles: sustained oscillations of fixed amplitude.
  • Jump resonance and harmonics in the output.

Phase plane

The phase plane plots velocity against position. Each initial condition gives a trajectory. The pendulum $\ddot\theta = -(g/L)\sin\theta - c\dot\theta$ is the classic example: small swings look linear, but large swings can go over the top.

In the simulation, drag the bob a little and let go, then try a large flick. Compare the trajectories in the phase portrait.

Lecture

🎬
Lecture video
Coming soon. The recorded lecture for this lesson will appear here.

Try it

Exercises

  1. Linearise the pendulum about $\theta = 0$ and about $\theta = \pi$.
    Show solution
    Near 0: $\ddot\theta = -(g/L)\theta$, a stable oscillator. Near $\pi$: $\ddot\phi = +(g/L)\phi$ (with $\phi = \theta - \pi$), unstable.
  2. Give an example of saturation causing trouble in a PID loop.
    Show solution
    Integral windup: when the actuator saturates, the integral keeps growing and causes a large overshoot after the error changes sign.
  3. What is a limit cycle, and can a linear system have one?
    Show solution
    A sustained oscillation of fixed amplitude independent of initial conditions nearby. A linear system cannot: its oscillation amplitude always scales with the initial condition.